EXPORT TO A USB

This guide shows how to export your clinical and wireless configurations from an X-Series defibrillator to a USB drive:

1. Enter the Supervisor menu
2. Select: “Display/Configuration:”
   
3. Insert a USB drive in the USB slot located on the right side of the Defibrillator:
   
4. Select: “Export Configuration”
   
5. Once the operation is complete, Select “OK”
   

IMPORT FROM A USB

This guide shows how to import a saved configuration from an X-Series on a USB flash drive to another X-Series. WARNING - These steps will overwrite ALL clinical and wireless configurations and replace them with the configurations saved on the USB drive. It will also reenable the Life-Threatening-Alarms (LTAs) if those were previously disabled. Contact ZOLL Technical Support if you need assistance checking/setting the LTAs.

1. Enter Supervisor mode:
2. Select: “Display/Configuration:”
   
3. Insert a USB drive in the USB slot located on the right side of the Defibrillator:
   
4. Select: “Import Configuration”
   
5. You will receive a Warning! that this operation will overwrite current system configurations and alarms.
   • Select: “YES” to proceed
     
6. Once the operation is complete, you will receive the following Message:
   
7. Select “OK”
8. The Defibrillator will reboot